« A Short List Of Facts On Digital Photography | Home | 6 Why’s for Setting up a Glamour Images Blog »

Repair That Canon Powershot SD Camera Broken Lens Barrier Yourself!

By norman | February 26, 2010

So many different people have asked us about fixing the built in lens covers/barriers/flaps on their Canon Powershot SD series digital cameras that I’ve gone ahead and written some instructions. Our lens barrier repair kit is a little tricky to replace on Canon SD series cameras but definately not impossible for you to do yourself. You will need patience, a good eye and a steady hand as well as a small screwdriver. We use dental picks, they work great!

To get things started, turn on the camera to extend the lens and then open the battery door and remove the battery so that the lens stays out. This allows you to easily work on the lens barrier assembly.

First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Most cameras have a drive ring, but some do not. If you don’t see one in your kit then your camera does not need one. Be certain that it will rotate slightly after installation, otherwise it is probably not installed properly and can cause the lens to get jammed.

Next are the springs and flaps. There is a small little tab that holds the spring in place when you put it on the ‘flap’ or ‘barrier plate’ as they are actually called. They are TINY, they are hard to hold and if you drop it… please take my advice and don’t drop it, ok? We do have just the springs available for purchase, but please try not to lose them.

Gently put the flap in the hole with the spring laying towards the post that the free end will mount on; then with something with a very small tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.

Do this with the flaps in the open position, they will stay in place if you get them seated properly. If everything pops off, just start again. Try not to stretch out the springs, they need to remain tight for the assembly to work properly.

Then gently put on the barrier cover, it’s a flat plastic ring. The tabs on the outer barrier cover match up with small slots in the lens housing and it will lock into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.

Now you may test your repair prowess! Put in the battery (cross your fingers) and press the power button! Did it work? Did it go flying across the room with a cute little *SPROING!* and maybe all the parts scattered all over the place? I hope not, but you’re not alone I’ve been there too.

Once it’s working nicely …you’re almost done with your first digital camera repair!

Next put the dual sided tape on the barrier cover. CAUTION: Make sure to take the tape off of the backing paper but DON’T remove the paper that matches the shape of the tape on the other side!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!

The tabs of the tape fold over the edges, if they stick out the lens cover will not fit properly and can jam up the lens. The tape lines up with one tab at about the 11 o’clock position, then fold the tabs over and press them in so they don’t stick out.

Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.

Fire up the camera again and admire your handywork! Good for you! You now know how easy… and yet still hard Canon digital camera repair can be, and the “Geek Squad” said that it was either unfixable or would be two hundred dollars and take several weeks to complete. Whatever Geek Squad… Whatever.

Hmm… I think I’m seeing the beginning of something big here; truely affordable Canon digital camera repair


Stumble it!

Topics: Digital Video Tips |

Comments are closed.